I am using STM32MP157F-DK2 for secure boot. I am using ecosystem release v3.1.1 which has TFA v2.4-stm32mp-r2.1. As per steps given by ST need to fuse publicKeyhash.bin to OTP from u-boot console using "stm32key fuse 0xc00000000".As OTP area can not...
I'm using latest ST official U-Boot release v2021.10-stm32mp-r1 and I'm trying to get OP-TEE working with ST's official Linux release v5.10-stm32mp-r2.1 and it's stuck after U-Boot:Starting kernel ... I/TC: Secondary CI/TC: Secondary CPU 1 switchin...
Hi ST Community,I have been trying to add the WLAN interface to my stm32mp157f-dk2 board with the distro "openstlinux-weston" and the machine "stm32mp1" without success with the following documentation:I have applied the kernel configuration given in...
Hi there, I'm starting developing on an STM32MP157F-DK2 kit, and I wanted to build my own distribution, starting from the distribution package (STM32MP1 Distribution Package - stm32mpu). At the first compilation, the bitbake st-image-weston takes rea...
Hi there, I'm following all the steps described in Distribution-package to compile the yocto build for STM32MP157F-DK2 (stm32mp1). And at the beginning of the compilation (bitbake st-image-weston) I am getting the message : .....openstlinux-5.15-yoct...
Hello We are using STM32MP157A-dk1 evaluation board. To this we are writing bare metal code in SEGGER Embedded Studio. We have written code for all three cores (A7_0,A7_1,M4). Individually we are able to debug(with limitations), For final testing...
Hi there, I just received the STM32157f-dk2 discovery board, and I just started to dive into the tutorials. I am trying to simply follow the step to just cross-compile and flash the kernel image. When I complete all the steps and reboot the board, th...
We have also deleted the OTG (USBC) hardware and have commented out the code to check for the OTG power., Otherwise we are using the basic defconfig and the DK2 devtree.
I am using PlatformIO extension on Visual Studio Code and ZephyrRTOS framework to run blinky sample code for stm32mp157c-dk2 board in engineering mode. my use-case is to debug only in engineering mode with A7 core not being active or running.Debuggin...
I'm working on project that required SPI with DMA .I'm working on STM32MP157C-DK2 board.I am trying to enable CONFIG_SPI_STM32_DMA macro in my config file getting error in zephyr driver due to DMA has not yet been ported on STM32MP1.Any suggestions.T...