Hi Team,There are two version of OSTL i.e. v4.0.0 STM32 MPU OpenSTLinux release note - v4.0.0 - stm32mpu-ecosystem-v4 and v4.1.0 STM32 MPU OpenSTLinux release note - v4.1.0 - stm32mpu-ecosystem-v4. what is difference between them both are at 5.15....
I'm encountering difficulties while attempting to connect and debug my STM32 microcontroller, and I'm seeking guidance from the community. I have erased the full chip flash memory and uploaded my code but suddenly I start getting these error messages...
Hi Guys,Please I facing problem to have a QT application fitting the DSI screen,it sounds like it is 400x240 and not 800x480. I`m probably missing something on QTor on the STM32MP157C-DK2.Can someone please help-me to correct the resolution and how t...
Hi,I have STM32MP157f-DK2 . I built openstlinux-5.15-yocto-kirkstone-mp1-v22.07.27 , distro=openstlinux-eglfs , and I try flash image to sd card.When I am flashing "FlashLayout_sdcard_stm32mp157f-dk2-trusted.tsv" I have different errors related with ...
Dear Sir/Madam,Thank you for reading my message. I have a newly bought STM32MP157F-DK2 but it doesn't boot the Bootlin's pre-build Linux kernel image. Its screen showed nothing (no boot messages, cursor, etc, as shown in the attached picture). I rece...
Hello everyone,I am planning to build an embedded project using a System on Module (SoM), and I am looking for a SoM board that supports bare-metal programming. Could you please help me find the best SoM board suitable for this purpose?
I've been following the STM32MP15 Discovery kits - Starter Package tutorial to set up my STM32MP157D-DK1 board and am having trouble flashing the SD card via the CubeProgrammer CLI. It successfully loads partitions 0x01, 0x03, then the board disconne...
please suggest me some displays for STM32MP157D-dk1 and if possible provide me some links for purchase,i want 4 inch display
Using OSTL 4.1.2 and build DISTRO=openstlinux-weston MACHINE=stm32mp15-disco on STM32MP157F-DK2. Found that while boot up serial console showing incorrect version of u-boot and TF-A. Although kernel version is correct i.e. 5.15.145.TF-A : v2.6-stm32...
Hey in stm32mp1 Im learning about yocto and build root ... So should the micro sd be flashed in the starting , or only the sd.img generated after the generation of the linux image ? for using it ? (Im a complete newbie to this..)