ST25 NFC/RFID tags and readers

Resolved! How to install en.x-cube-nfc4.zip?

I'm embarking on a project with the ST25 NFC chip. ST provides an XCube pack but I can't figure out how to install. MXCube complains that it can't handle the .zip file (en.x-cube-nfc4.zip). Should I have kept my old version of MXCube? I just updated ...

Resolved! ST25R3911B-DISCO - I2C - SCL/SDA labels on PCB are switched

I have two ST25R3911B-DISCO boards and while recently trying to communicate over I2C - after alot of troubleshooting I discovered that the labels on P203 for SCL and SDA are incorrect and have been switched.The schematic is correct - I traced the pin...

Resolved! Read the RFID of a card with NFC03A1

I read all the .cpp and .h library but I can't find any routine that shows the RFID of the card, can you help me ?

Resolved! Recommended smartphones for ST25DV64K

Hello,We have experiended RD/WR problems with standard smartphones.Is there any list of recommended smartphones for operating with ST25DV64K?Regards, Ramon.

Resolved! file or application not found mean ??

Resolved! Is there some additional documentation provided by ST which can help me to certification my Device which uses ST95HF? I am using that chip like Reader/writer, Card emulator and pear to pear device. Thanks

Resolved! Question about NDEF writing delay with NFC04A1!

Hi, i'm using NFC04A1 with NUCLEO-F401RE board, and im very new on this.Trying to send NDEF texts (88bytes) with <1sec period ,but i cannot make it short less than 1.2sec.Here's the while loop code with 1.2sec period.while (1) {  NFC04A1_LED_ON( ...

Resolved! Gerbers of NFC card reader board based on CR95HF (X-NUCLEO-NFC03A1)

Hello,Kindly provide us the gerbers of X-NUCLEO-NFC03A1.We wanted to know is it 2-layer or 4-layer board?ThanksSneha J NachinolkarHardware Development Engineer+91-8805452817

Resolved! STEVAL-SMARTAG

Hi,I'd like to reproduce the STEVAL-SMARTAG but I can't find the Altium project on the website. I have found the Altium files for the reader board (https://www.st.com/content/st_com/en/products/evaluation-tools/product-evaluation-tools/st25-nfc-rfid-...

Resolved! Is it possible to use only the UART interface of the ST25R3911B-DISCO instead of the USB?

I'm using a ST25R3911B-DISCO for a project and I need to use the UART interface, instead of the USB one and the software provided by ST, to send commands (like INVENTORY, READ BLOCK, WRITE BLOCK) and receive the corresponding information.Is it possib...