Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Dear All,I am using STM8L ...I had tried ST library functions to write option bytes but they aren't written.the code as following :-halt_opt_byte = FLASH_ReadByte(0x4808); if( halt_opt_byte != 0x02 ) { FLASH_ProgramOptionByte(0x4808, 0x02); }Still...
Hi, How can i define global variable in COSMIC C Compiler for STM8S? Is there any document which can explain for global variable definition in COSMIC C Compiler?Regards,Nandish Jasani.
Dear sir,I am using stm8s105c6t6 controller for one of my projects. i am using AWU for low power consumption.when i was add the AWU with MVR on code in to my source code led's are blinking irregular (some times it is glowing for 1s).I am using PWM fo...
Iap sample source is not present in st homepage.Can i have iap sample source?
Hello, im quite new to the stm world. Recently i got into a project where i might need alot of mcu's doing basic stuff. After a little searching i found that stm8 mcu's are very cheap. I already got a STM8S103F3P6 and a st-link and so i tried to foll...
Attached is based on PM0044 'STM8 CPU programming manual' Doc ID 13590 Rev 3, 2011-09.LibreOffice Calc workbook with five sheets:1st Byte - instructions with no pre-code (i.e. opcode is one byte) or whose first byte is a pre-code (i.e. opcode is two ...
Hello all,I have an application based on the STM8S003F3 where invalid logic levels could appear on the UART RX line. (By design due to the ground offsets in a bigger system.) In some cases the UART misinterprets bytes mainly when the low level of the...
Is there any way to programm STM8 using a command line software ? I tried with ST-LINK_CLI but that is just for 32bits, no SWIM option
Hi,I am trying to develop a switch that can turn on various loads in motorsports vehicles. I made a prototype using the VN7003ALH. The first thing I tried to switch on was a cooling fan. Which specified a 20 amp load max (obviously on start up it wil...
We are still buying M68AW128ML70ND6 (SRAM) from brokers. Its datasheet does not specify any RoHS status. We would like to know if the part was ever manufactured as ROHS compliant ? If so, from which date code was the part RoHS compliant ? Thanks in a...
