Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Hello!(I am working on my school project of IOT and trying to build a little IOT system.)I follow the tutorial https://developer.ibm.com/recipes/tutorials/vibration-monitoring-using-mems-accelerometer-and-ibm-watson-rules-and-actions/#comment-7074and...
I have installed this software from ST "Remote Console for GP ST7540" on a few computers running on Windows 7 and on Windows 10 with compatibility mode set to Windows 7 and unable to run the application. On all computers the software installs withou...
I get a swim error [30006] when trying to connect to an unmodified STM-S08-DISCO board (configured for S001J3). I viewed the SWIM signal at pin 1 of the socket and the voltage levels do not look valid. It is powered by USB and the STLINK LED does f...
How can I solve this problem ?
Hello, I have been using the spbt3.0dp2 chip for my designs. Will these chips be available again?
The CANH and CANL signals are reversed on the DB9 connectors. The schematic shows CANH from the TJA1043 driver chip going to pin 7 of the DB9, and CANL going to pin 2. This is the standard for use of DB9 connector on many CAN devices. In fact, the...
I am trying to find ST micro part from the marking code on it. I think it might be an ESD protection diode or a Transistor. Marking on it is either DUG or 7CCan someone help me find the part number from this?
please provide suggestion and example of multi channel adc reading on interrupt
