Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Hello everyone, I am aiming to build a desktop application for configuring and monitoring IoT devices (e.g., routers, switches, ciphers, sensors, etc.). To achieve this, I am considering two architectural approaches:First Architecture:The desktop app...
Hello everyone,I'm trying to get an RTC output on pin C13 using a Bluepill STM32F103C8T6, but it's not working.I have connected LED to PC13 to see the LED blinks every 512hz but its on all the time.Can someone help me.
Hi,I have issue on Key Establish and Wrap/Unwrap example.I have X-NUCLEO-SAFEA1 and NUCLEO-L476RG for testing.I downloaded X-CUBE-SAFEA1 from ST web site, version is V1.2.2. Here's what I tried.I ran paring example. I commented out "_FORCE_DEFAULT_FL...
For some reason, I am not being able to set the frequency in the launcher but can change it successfully in gui.I am getting this invalid choice error:But I dont see any error in the argument:
Title edited to make clear that this is emulated EEPROM - in the MCU's Flash.How to reset the EEPROM every time a new code is uploaded?Is this possible? Thank you very much.
Hello everyone,I’m an intern software engineer currently developing a Qt-based desktop application for configuring and monitoring IoT devices running Zephyr OS.At the moment, I’m researching which protocol would be best suited for this purpose. I ini...
Hi Is it possible to convert I2C signals to USB signals using "STOTG04E"?
Dear Team,We are using M24C04-D in our design and getting CRC error at 400KHz.We observed that almost every time only 1bit change i.e SDA not able to rise to 1. Please see below image. There is no such issue at 100KHz. Could you please tell what cou...
Hello,I recently came across a question that I would like to ask you for help with.I am considering using closed loop stepper motors and drivers in my 3D printer. If I had two stepper motors for one axis, I would connect them in parallel. Is this als...
