Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
I want to use count external pulses count coming on Timer 1 channel 1 .I wrote following code. the couter starts counting as I apply external pulses.but the counter doesnot go upto 65535 value. it gets reset intermittently.I want to use counter to co...
Hello,I'm repairing SICK sensor and found the unknown component. Please help me recognize this part and possible replacement part.Thank you.
We need the Material declaration of BAT54ZFILM, obsolute product.Please send it.
Hello, i use stm8l-discovery board with stm8l152c6t6.I need to sniff swim protocol and wrote the asm module for this purpose.This module uses WFE instruction to wait PIN transition and TIMER4 for timeout.If I use WFE for TIMER4 or PIN from only 1 sou...
How do we increase the voltage obtained as a result of the current measured in x-nucleo ika-01a1
Hi,This is the first time I am asking on this forum.Could you please help me with Some design help.I have designed circuit with eDESIGNSUITE for following requirements.1.Input voltage:180-265VAC2.Output Voltage-17V 4.2Afrom the design, it resulted ou...
Good morning all. I hope you are well.My quest is for the VND600-SPI am using this power switch for the LED drive.I drive LEDs using the Pwm signal for dimming the power of the leds. I use 1 khz frenquence input f the vnd600-spProblems arise in this ...
Hi :) I am using an STM8L151G6U6, and found out I missed something in the datasheet.Datasheet is DS6372: https://www.st.com/resource/en/datasheet/stm8l151g6.pdfRM is RM0031: https://www.st.com/resource/en/reference_manual/cd00218714-stm8l050j3-stm8l0...
