Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
the DOS window says synchronization OK then gives a unknown exception then says ERROR and dosnt load code any ideas?
Hello community, I am trying to debug my STM32f103C8T6 bluepill board (probably using fake chip) on STM32CubeIDE but there is something goes wrong about both GDB and Local Server. In debug configuration, When I set debug probe to "ST-Link GDB Server"...
can anyone suggest that which is the best for battery application linear regulator or switching regulator.Regulator specifications should be 1) Input voltage 5V-48V 2) 2A current rating3) Output voltage 5V.3) Ultra low Quscient current.please suggest...
Hi,I am using STM8S105c6 , I have used timer1 software interrupt, to generate PWM. but I am not able yo control it, not duty cycle not frequency plz check code give and correct me.Thanks in Advance/* * BMSBattery S series motor controllers firmware *...
Hi =) Short version: should there be time (cycles) between updating ARR/CCR registers and generating an update event by setting the UG bit in TIMx_EGR?Long version:I am using one timer, which is automatically enabled (triggered) by another timer.I ma...
I use eDesignSuite to simulate LED5000. In my application I want to use the same circuit for a variety of loads (different LEDs, different current setpoints). From individual simulations I found a set of compromise component values, e.g. 6.8uH for th...
Hello Dear,I am using STM8S105C6 microcontroller and want to toggle the GPIO, But I am not able to do this.Will you please help
I'm using STM8AF5288 and the COSMIC as my IDE.Everything working great accept for interrupts using.The interrupt are being fired as I accept but on returning from the interrupt the PC is out of the program memory addresses.It is happening with extern...
Hi Sir/mdm,I'm now working on the bluetooth section's code and require some technical support.End goal is to get the BLE scanner working via GAP_OBSERVER_ROLE to extract BLE advertising(filter by company identifier and major/minor)Here is the issue a...
I am trying to generate a delay in STM8s103 using Timer peripheral TIM2.but on equating the values to the Prescaler register(PSCR) and ARR. that is not happeninglike I debugged my code step by step and on seeing the values of TIM2 registers, they ar...
