About bakialmaci

bakialmaci · 2021-02-20

In debug configuration,When I set debug probe to "ST-Link GDB Server", I got "Failed to start GDB server Error in initializing ST-LINK device."When I set debug probe to "ST-LINK (Open OCD)", I got "localhost:3333: The system tried to join a drive to ...

bakialmaci · 2021-02-20

Solved ✔�? I rearranged my debug configurations like that,Everything works fine!Regards.Baki ALMACIHacettepe University Electrical and Electronics Engineering.

bakialmaci · 2021-02-20

Nobody is blaming anyone. Please do not argue here.

bakialmaci · 2021-02-20

Did you find any solution?

User statistics

User Activity

Hello community, I am trying to debug my STM32f103C8T6 bluepill board (probably using fake chip) on STM32CubeIDE but there is something goes wrong about both GDB and Local Server.

Re: Hello community, I am trying to debug my STM32f103C8T6 bluepill board (probably using fake chip) on STM32CubeIDE but there is something goes wrong about both GDB and Local Server.

Re: Hello community, I am trying to debug my STM32f103C8T6 bluepill board (probably using fake chip) on STM32CubeIDE but there is something goes wrong about both GDB and Local Server.

Re: Error message from debugger back end: The system tried to join a drive to a directory on a joined drive.