Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
The M95M01-DWMN3TP/K (NVM) is connected to a custom MPC5775B board. It works with a 5 MHz clock. According to the datasheet, it should support frequencies above 8 MHz, but it does not work with an 8–10 MHz clock or higher.
Hi ST team:Could you share the IBIS model of Flash<M95512-WMN6TP> for signal simulation per our customer request,ThanksBRLisa
Hi ST team, I was hoping to ask for your advice on the recently delivered product to our industry. The control mechanisms of the product are managed with the STM8S105C6T6TR. After the careful removal of the conformal coating, the STM information doe...
Himy name is LambertWe are using a component : STPSC2H12B-TR1 and STPS3L40UF in our designs. can you please share the component MTBF & FIT values .please we need this inputs on high priority RegardThank you so much
We are currently evaluating components for HDMI Interface, and HDMI2C1-14HDS looks suitable candidate for ESD protection for HDMI including protection for all signals. The HDMI2C1-14HDS is obsoleted part so we need some drop-in replacement for this ...
Hi everyone! I'm excited to share the official release of StepperHAL_STM32F4x1, a C++ Hardware Abstraction Layer (HAL) library for controlling stepper motors on STM32F4x1 microcontrollers, fully compatible with the Arduino framework.Key features:Trap...
Hi, can someone tell me to which signal are connected the 6 layers of the board? Thank you so much
I need help identifying a particular ST SOIC 8 op amp. It has the markings: 204/ 9125 I hope to hear back from you as I am interested in this op amp but I cannot find out what it is.
Hi All, Looking to see if there are any replacements for the VN05NSP. Attached is the datasheet for it. I found VN5E006ASP-E but am not sure if it could work. Attached is it's datasheet as well. Thanks for any help. Byron
We are interfacing a Chafon MU910-M UHF RFID reader module with an STM32F103C8T6 (Blue Pill) board using UART communication. During loopback testing, we observed that individual UART ports are functional and can transmit single byte, but when attempt...
