About AJAY S

AJAY S · 2024-12-04

Hi There, I'm looking for thermal resistance Rtheta-JA ,Rtheta-JC Part M24C16-DRMN8TP/K .Kindly ,provide the details , I need this for thermal simulation. Regards, Ajay S

AJAY S · 2023-01-22

AJAY S · 2023-06-28

You can Set GPO as High and Low when RF feild is available.By using GPO_EN

AJAY S · 2023-01-23

thank you for your support

AJAY S · 2023-01-23

MY host is 3V3 sir,but my sensor is 1v8 thats why i had confussion.

AJAY S · 2023-01-23

this is my shematic design sir here i2c i use 1v8 is that okey to communicate STM32WBMMG chip. in between 3v3 to 1v8 level shifter is required? or not thats my doubt

User statistics

User Activity

Thermal Resistance of M24C16-DRMN8TP/K EEPROM

Hi Team, i used to design STM32WB5MMG IC for my application. i have temperarture sensor MAX30102. i need to communicate with mcu with i2c .its working on 1v8.shall i connect directly to mcu i2c? or 3V3 to 1V8 level translator is required inbetween?

Re: Multiple pulses are generated on GPO pin for ST25DV64KC micro, when NFC enabled mobile is kept n

Re: Hi Team, i used to design STM32WB5MMG IC for my application. i have temperarture sensor MAX30102. i need to communicate with mcu with i2c .its working on 1v8.shall i connect directly to mcu i2c? or 3V3 to 1V8 level translator is required inbetween?

Re: Hi Team, i used to design STM32WB5MMG IC for my application. i have temperarture sensor MAX30102. i need to communicate with mcu with i2c .its working on 1v8.shall i connect directly to mcu i2c? or 3V3 to 1V8 level translator is required inbetween?

Re: Hi Team, i used to design STM32WB5MMG IC for my application. i have temperarture sensor MAX30102. i need to communicate with mcu with i2c .its working on 1v8.shall i connect directly to mcu i2c? or 3V3 to 1V8 level translator is required inbetween?