I recently created a digital potentiometer breakout board for the MCP4541-104E/MS, where I would set the resistance value dependent on a particular wiper value. Here is the schematic and layout (I changed the pullups from 10k to 4.7k): Here is the c...
Hello everyone,I’m seeking guidance on using the STEVAL-USBI2CFT as a voltage shifter (to 3.3V) and a communication bridge between my laptop and an MSP430 IC. According to UM3226, the STEVAL-USBI2CFT uses the FT260Q chip and should not require extra ...
I can't find reference to this component, I'm trying to repair/understand the equipment. Does anyone recognize this part? Secondly, I couldn't find any reference on the ST website about component identification markings. A link or reference would b...
Technically, on a practical level, how to integrate overcurrent detection (OC COMP) for dynamic adjustments into the FOC algorithm?
I have four sensor tile STWINKT1B kits. I want to simultaneously capture accelerometer, temperature, and acoustic data from all the kits and set up an integrated dashboard. Further, I also want to extend this project by creating an IOT Hub using eith...
A 24 VDC, 10 A AC/DC converter design has been done using the eDesignSuite on the ST website. The converter gives a very stable output at 24 VDC. We did not encounter any problems when we used the converter at normal loads below 10 A. However, when w...
A 24 VDC, 10 A AC/DC converter design has been done using the eDesignSuite on the ST website.The converter gives a very stable output at 24 VDC. We did not encounter any problems when we used the converter at normal loads below 10 A.However, when we ...
Hello. I am a very beginner in STM32 and in electronics overall and I have a really big issue with Keil uVision5. I was following my tutorial, the guy in the video told me to create a project in CubeMX and then generate code and open in in Keil uVisi...
What is the MSL level on this part? I don't see it on the datasheet?
I have two Sainsmart STM-5045 4.5a stepper drivers that i would like to get running, i had a pretty tough day last week with my machine and had to put this aside for a bit but i would like to see if i can salvage either of them today.The order of eve...