[IPS1025H-32] Is the output type of the diagnostic pin of the IPS1025H-32 push-pull or open-drain? Is its default output voltage user-controlled?
The STEVAL-IFP046V1 uses an optocoupler output and I only want to use a non-isolated circuit
Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
The STEVAL-IFP046V1 uses an optocoupler output and I only want to use a non-isolated circuit
Can anyone please help me with this problem. I want to store some values while the processor is in Standby mode. As, when it wakes up all the variables are reset. How can i make the variables static in case of standby mode. Any help will be appreciat...
I have old eeprom, aprox of year 1998 of manufacturing. It's written on it ST 5880F 9948K SINGAPORE. Could somebody support me with datasheet for it.I need to make backup of it.
I'm using a Teseo-LIV3FL GNSS module for my project and trying to set the low power mode settings using Teseo-Suite software. Tried using the Low Power settings from the wizard but after get the fix it still draws around 50mA of current.Expected beha...
I have a Teseo-LIV3FL GNSS Module and I want to configure the low power mode configuration using Teseo Suite software. Here's my setting I was expecting after two fix reports my Teseo will go to sleep mode in 180 seconds, but after getting bunch of f...