I have Connected the two shunt resistor I am reading the current but when I connect one load another load current also updating.

HiThank you for replyI have three ST10F276 Boards in that One is completely not detected,second one detected once after that not detected, third one continuously detecting ,For your information All same boardsplease suggest Why I am getting this prob...

HiActually I downloaded the ST10Flasher 2.4B and checked with ST10F276 Controllergetting the No acknowledge ErrorI have done P0L.4 to GND and P0L.5 to HIGH and did reset the controllerplease give me solution