Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Dear STMicroelectronics Community,I hope you are doing well.I am currently reviewing the datasheets for your STR1550 and STR2550 transistors. While both documents provide detailed electrical characteristics, I noticed that the collector-emitter cut-o...
I am creating a program to write data arbitrarily to the M95M04. The M95M04 has 512-byte pages, but does writing have to be done in page units?For example, when writing 8 bytes of data starting from address 8, is it acceptable to specify address 8H a...
Hi,I am trying to understand some features of STHV200 Dual channel ±100 V, high voltage 3 A linear amplifier and 2 A pulser transmitter.I could not find a detailed datasheet of the product. Only data brief. I want to use it to amplify the received lo...
From the listed applications, it is noted that RF3L05150CB4 is suitable for HF and VHF communication ranges. However, the available application note mentions frequencies at 520 MHz and 860 MHz. Is there any application note available specifically for...
Our customer has requested a material declaration report for M93C86-WMN6P. We purchased 1,000 pcs from Avnet back in 2016. However, it appears that this part is now inactive, as I couldn’t find the part number listed under M93C86-W. Could you kindly ...
The board has passed a authentication test so I currently believe it is a me issue. I have been trying to get a CAN bus going using the STM32 Blue Pill board with a TJA1050 CAN Transceiver, but for some reason even with basically copy pasted example ...
I am attempting to use STPOWER Studio to run a thermal simulation but every time I start a simulation it just sits at 0% complete, showing Simulation in progress: iteration counter [ 0 / 63]. Has anyone run into this problem? Any suggestions on what...
Please help me to get full datasheet for part#STHV64SW.Is there any need for an NDA?What is the process?
Hello,I’m using an STM32H562RGT6‑based board with a built‑in ICM‑20948 IMU and ICP201xx pressure sensor. When I run bare‑metal code (no RTOS) the I2C communication with both sensors works fine and I can read data. However, as soon as I enable FreeRTO...
I have a question regarding the use of the STSAFE-A110.Currently, the default I2C address of the STSAFE-A110 is set to 0x20. It is possible to change this address?If it is possible, could you please explain how to do it? Thank you in advance for your...