Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Hi,I would like to know the power dissipation of "STP6N120K3" under normal operating conditions or the formula to calculate PD and its "Thermal resistance between Junction to Board (°C/W) -RθJB" which is not specified in the datasheet.
I purchased several X-NUCLEO-IDW01M1 expansion boards. Some boards operate normally, while others reset approximately every 3 seconds and do not operate normally. I don't know if it will help but attach the log.
I have comunucation 485 when start the aplication after 10s begin error "FE".Baudrate1152008bitsNine paratyI use transiver maxin 485 and pin "DE" by hardware.
someone knows it? MTGP437
Hi,I wish to use ACST310-8B in light dimming application.1. As shown in typical diagram of Phase Angle control, in the datasheet of ACST310-8B, can we avoid using choke/inductor in series with load?I believe this choke/inductor is needed for di/dt pr...
When we wrote data at 0 location, same value getting reflected at 32768 and vice versa. Same behavior for 65536 and 98304, 131072 and 163840, 196608 and 229376. Not sure why it is writing at two locations same information even though we have written ...
I am attempting to set the output states of an L9825 using its SPI interface, but no matter what byte is transmitted, the returned diagnostic byte is 0x88 and the output state is unaltered.clock frequency : 1 MHzclock polarity: lowclock phase: data c...
This driver is used (2 per module) in a fairly new product we have been shipping 10k modules in past 6 months. Until recently, we have had no driver failures. Now we have two returns from a customer with a driver failure on each.On one unit, one chan...
