When installing some StellarStudio plugins http://*.srxstudio.org , you can meet the issue : sun.security.validator.ValidatorException: PKIX path building failed It is typical IT Issue :face_screaming_in_fear: in each corporate company. “"Path bui...
Dear all, We are thrilled to announce that as of today, March 1st, 2024, SR5E1 device support in StellarStudio is available to the mass market ! This means that any user can effortlessly download the official StellarStudio installation packag...
Hello everyone,I'm struggling trying to compile an old project without having to regenerate the configuration files, this project was made under the ppc freegcc with vle support V4.9.2 ,I tried to compile using the last actual version(4.9.4) and I'm...
Could the BAF_BYPASS field in the BAF configuration DCF register by modified by the user.If yes, under which module can I find it? I'm unable to find this in Lauterbach debugger.If no, how can I skip the BAF section during the bootup? - My device has...
Could you send us the datasheet of L9966, we want to know the difference of L9966 and L9966CB. Is L9966 EOL?
Dear All ,SPC5Studio Update sites are backin case of critical requests :contact us on credentials@spc5studio.com
Using SPC5 Studio 6.0-Clarke Error: Pin PIN_TCK: cannot find FunctionRef MSCR_512_0Error: PIN_TCK: Cannot find FunctionRef for MSCR_512_0Error: Pin PIN_TDI: cannot find FunctionRef MSCR_512_0Error: PIN_TDI: Cannot find FunctionRef for MSCR_512_0Error...
hi, I would like to know if it is possible to read mcu SPC56EL60L3 with usb / uart adapter with software SPC5 FLASHER?
I am working with a SPC582B60E1 64 pin Flat pack chip. I am trying to program GPIO11_INT24_PWM16_CAN4SYS1_RX_WKPU pin 53 as a PWM output. But I am not sure if it is even possible. I consulted the SPC5 LLD Drivers for RLA components document for PWM l...
I am doing my bachelors degree and have a task to get two boards communicating using the CAN bus. I just got the boards and they pretty much said "have at it" without any prior knowledge. By now i know most of the really basic stuff about the CAN bus...
Good morning everyone,I'm facing some trouble compiling a project made by SPC5STUDIO 5.8.1 the project is configured by written makefile and rule.mk file.I tried with the last release (V6) and it's not working after importing the project (I did save ...