I have setup ADC1 & ADC2 for dual mode sampling in CubeMX for the Nucleo-H743ZI, when I change the input channel for ADC2 then Cube sets the "DMA Access Mode" to disabled for both channels. Is this normal behavior?

[Nesrine.JLASSI]

Hi @Wde G.1​ 

Could you please share your ioc file to check the issue .

Best regards,

Nesrine

[Wde G.1]

Hi Nesrine, Thank you for picking up this issue. See the ioc file attached. Regards, Walter. Op do 30 apr. 2020 om 06:52 schreef ST Community :

[Nesrine.JLASSI]

Hello @Wde G.1​ 

I think you forgot to tie up your ioc file.

Regards,

Nesrine

[Wde G.1]

Hi Nesrine,

I do see the ioc file in my send email:

Maybe the server is blocking it?

Should i resend it?

Regards,

Walter.

[Nesrine.JLASSI]

​Yes please.

Regards,

Nesrine

[Wde G.1]

Next try See attached "EmStat4_fw_test_nucleo.ioc" Op do 30 apr. 2020 om 10:50 schreef ST Community :

[Wde G.1]

Can I attach it in here? I don't see a attach icon, only link

[Wde G.1]

I have send it again, you got it?

[Nesrine.JLASSI]