Ask questions and find answers on ST25 NFC/RFID tags and readers, including connectivity implementations and antenna design.
I have the X-Nucleo-NFC30A1 with the Cr95HF chip. My question is: Is the Listen Mode supported for Type A tags?I used the X-Cube-NFC3 v2.0.0 and managed to get the Tag Detector working. But I am trying to implement the Listen Mode and am facing probl...
Hi, I'm using RFID reader ST25R3911B to read/write on ISO15693 card. I'm unable to perform a write to the card and i'm using "Writesingleblock" function mentioned in code/lib cube-nfc5(ver 1.2). I followed the steps which was mentioned in an earlier ...
I can't seem to find this board. It uses the STM32L476. There are some other development boards shown with this controller, but not the ST25R3911B-DISCO.
The Eval kit GUI allows to evaluate the ST25RU3993 whatever the regional settings/frequency are (840 - 960MHz). This wide-freq version seems to be reserved for evaluation purpose only while the standard version is freq limited (to match regional reg...
Hi,I am using one of the evaluation boards to test 3993. My objective is to determine the change in the phase of the reflected signal. For this reason, I use the movement detection mode that shows the Phase of the tag using the linear I & Q RSSI valu...
We've connected CR95HF with arduino uno via UART but it seems to give random outputs on the serial monitor.The arduino code:#include <SoftwareSerial.h> SoftwareSerial BTserial(4, 5); void setup() { // put your setup code here, to run once: ...
HiI am new to NFC solutions and I have to design a product that can read NFC tags inside an area of about 30x40cm. The tags won't be far away, I think less than 10cm. But they are all placed inside this area, with the wire-antenna around them.Is it p...
Hello,Where can I find it?I would like to have the pinout of the RF board in order to connect it to another board than the ST25 detection board of the kit.Thank you for your help.Regards,Jean-Pierre
I am in early development of a board with an ST25DV64k, and am currently not doing anything to communicate with or configure the ST25DV. The I2C bus is shared with another device. The ST25DV addresses are 0x53 and 0x57 (7 most-significant bits), an...