IBIS Model - M95020-WDW6TP
Hello, I am looking for the IBIS model of EEPROM (M95020-WDW6TP) for the SI analysis. Do you have it available?Please let me know.
Others: hardware and software
Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Forum Posts
Not able to print Floating Values using STM8S103F3P.
I am doing a Current, Voltage Measuring project using INA219 Current Sensor and using STM8S103F3P Mini Development Board. And monitoring the data in Serial Monitor. But I am not able to read/write Floating Values. For Eg: Multimeter is measuring 21.2...
USB PD V3.0 Source (Provider) and UFP (Device)
I want to connect a Q7 board to a tablet via USB. The Q7 board is a power source (provider) and a USB device (UFP). What USB PD V3.0 solution is available? Something like STUSB4700 with PD 3.0 and not only for Power-Adapters would be great.
Request CMRT, EMRT new(latest) version
Dear Ms/Mrs/Ms Hello, this is Aaron who in charge of APG in WT Korea.I would like to receive CMRT, EMRT new(latest) version. CMRT : ver. 6.4(Revision April 26, 2024), please refer to the attachmentEMRT : ver. 1.3 If you have any questions or concerns...
Assembler examples requested
I am new to STVD. I would like to make some assembly level programs. Is there any assembly example programs ? please help
Old versions of STVD required
Any body can post the link to down load old versions of STVD
Resolved! Mosfet
I am really confused about driving mosfet. read many documents regarding this. some documents says gate current may be 2.5A, some says it may be 50mA.what is the actual formula to calculate gate current?I am using IRF510 (H bridge conf.) at 24V, 700 ...
Debugging Error with STVD version 4.3.12
I am new to STM 8I have just started assembly level programs on ST visual Develop. Version id 4.3.12.I can not debug my test program.When ever I start debugging and clicking run command the IDE hangs. I use windows 7 . Please help
Resolved! "The interface firmware FAILED to reset/halt the target MCU" .txt with STEVAL-SPIN3202
Hello,I am working with STEVAL-SPIN3202 to develop motor control solution. I am using the Motor Control Workbench 6.2.1. I could generate the project using the workbench, however when i Connect the evaluation board, window with FAIL.txt opens which r...
Resolved! What are these K7U826
Hi,cleaning out my drawers and found some 8-pin IC’s wirh the marking: ST CHN NESSSN K7U826 Does someone know what these do and have a data sheet?Thanks,Bas
