Others: hardware and software

Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.

Forum Posts

Sorted by:

Sign In to Post

Resolved! I have an old PSDPRO programmer with no power cable. I need to flash some PSD503s. Does any one know what the output is of the AC Adaptor?

Resolved! on the st8's that have a DAC, can 5VDC be applied to vref+? Or, is there some alternative method to get an output swing of 0-5V?

About operating voltage of ST_M24512-r.

We would like to confirm questions below.ST_M24512-r1. Do you have datasheet for information about SCL speed and minimum Vcc? 2. Is our understand correct that the minimum Vcc of ST_M24512-r is 1.8V with our using SCL 400 khz ? 3. Related no.2. ...

Resolved! I am new to M24C04-W EEPROM ic please provide the read/write driver for this.

I need an Account Manager or ST Micro Sales Rep for Broadcom project

Please check who is Broadcom Account Manager in ST Micro, and please reach me at:sean-sc.chen@broadcom.com

I want to power a receiver (ISB68RX and ISB68WA) with ISB047V1T, but ISB047V1T keeps reseting after 5 seconds. It resets when it is powered via usbc, but when connected via micro-usb it stops blinking the leds and it is not recognized by STWBC GUI.

Where can I find reliability data for ST3232BTR IC?

USBLC6-4SC6 for EFT and lightning protection

Hi,Can USBLC6-4SC6 be used to protect an IO from EFT (IEC 61000-4-4) and lightning (IEC 61000-4-5)? I do not see any specification for these standards? Thanks.RegardsGordon

M95M04-DR EEPROM roll-over issue

I am working with the M95M04-DR eeprom. In my program, I must save logs of data inside the EEPROM memory. I wriite data in chunks of 25 bytes.I have written 11 chunks of data ant noticed a problem. I have a function to read back multiple bytes of dat...

What is the Top marking of M34E04-FMC9TG