Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Hi all, my team is experiencing some boards have failure of their STUSB4500 sink PD controller. We have not 100% determined the cause yet, but I found that our implementation is only using 0.1uF caps for the VREG 1V2 and VREG 2V7 decoupling. This is ...
Hello Team,We are using the "ST33KTPM2X32DKG9" part TPM IC. I would like to know the I2C address of the TPM IC.Regards,Sampat
Hello everyone,I’m working with the 1N5822UB1 Schottky diode and need forward current (If) vs forward voltage (Vf) characteristics at -55°C. The datasheet only provides graphs for 25°C, 100°C, and 120°C, but my application requires performance data a...
M95P16 data sheets says chip erase cycle is 100, but an5866 says chip erase counts as a cycle every page. Which is correct? Datasheet:AN5866:
Hi Team, It appears that the varistor turned on at a voltage lower than the value specified in the datasheet.・Detailed V-I characteristics of the varistor・How significant is the variation between individual varistors?・Once a varistor turns on, does...
I have a STEVAL-MKBOXPROm and I flashed "STM32CubeFunctionPack_DATALOG2_V3.1.0" (DATALOG2_Release.bin) to it. In the ST BLE App, I can start and stop an acquisition, edit which sensors are logged, and edit the fillenames. However, the acquistion_inf...
Hello STI would like to ask about is it possible to change the STUSB4500 FTP_KEY default values through SMBUS interface? If its possible, could you suggest the appropriate step to do so?
Hello.Forgive me for what might be an incredibly "noob" question, but i'm not ashamed to admit that I am, in fact, a noob.I've been trying and failing and trying and moderately succeeding over the last few days using NanoEdge AI Studio creating an au...
I have experience with PIC and AVR microcontrollers, but they lack the good debug features of the STM8 series. Furthermore, these microcontrollers aren't cheap. While looking for simple and inexpensive chips, I keep coming across the STM8 series.Mast...
Dear ST Team,I am using STM8L052R8T6.I have already configured an external interrupt on PC0 (PORTC, pin 0).Now I want to configure an external interrupt on PF0 (PORTF, pin 0) as well.Since both pins have the same pin number but belong to different po...
