Hello, I've downloaded the provided .lib file for p/n STD13N60M2 and created a part for it in LTSpice, but am not having any luck getting it to work correctly. I've created a circuit with a half bridge and get the expected results when using the mode...
Hello,I currently work with an STM32L496ZG chip and the EEPROM emulation driver (download on https://www.st.com/en/embedded-software/x-cube-eeprom.html).In the "eeprom_emul.h" file, we have the next macro :#define PAGE_ADDRESS(__PAGE__) (uint32_t)(...
Hi, I use CLT01-38SQ7. In datasheet (DocID028182 Rev 1) is not clear to me how to use Vcs pin (24V sensor power supply sensing input) for UVA purpose.In Figure 7. “Logic status of the SCLT3-8BQ7 power supply�? voltage ranges of Vcc and Vc are shown, ...
We are using USBUF01W6 as EMI filter for STM32F207VCT6 in USB D+ and D- lines in Full speed mode and we have connected VBUS (5V) at pin 3.3V pin of USBUF01W6. Does this make sense to you?NOTE: This question and answer originated from a customer suppo...
I have to read this ARM926 by JTAG connections but I don't have MCU pinout. On web I can only find a datasheet without pinout description.
Hello...Is the STG3157 suitable for headphone-level audio? I need to switch between the inputs of two microphones and put one of them into a small audio amp IC.Thanks!--Jim Newton
I can't find any information about VN380SP at the st.com siteIs VN380SP discontinued? Deprecated product?
I was planning to use STP15N95K5, for one of the power converter application. I have RMS current for the switch around 4 A with repetitive peak currents around 30A (0.2 duty cycle with a frequency of operation of 140kHz). The switch operates at a DC ...