Using the latest CubeMX 6.9.0 on Ubuntu 23.04 The following has happened quite a few times in the past years , also on previous Linux and CubeMX versions. Now would like to raise this issue as it's becoming very annoying now doing more work in Cu...
We are pleased to announce you that the official release of STM32CubeMX V6.12.0 is available. What is new in STM32CubeMX V6.12.0?New MCUs/MPUs series : STM32WB0 ,STM32MP25XX and STM32C071XXAdd support new CPNs STM32G4: Add support STM32G4 'Z’ and STM...
According to different STM32MP1 documentation such as STM32MP1-Peripheral-USB_Host_interface_USBH or STM32MP1-Peripheral-USB-On-The-Go-Full-and-HighSpeed-interface presentation there is two USB phy, one dual port HS phy and one single port FS phy. In...
I want to regenerate all my files, originally for the stm32mp157cac for the stm32mp157fac, in particular the devtree files. I suspect that the files are the same but I need verification. If they are not the same, how do I go about the update (witho...
We're using the ST v5.0 eco-system and v.6.9 of STM32CubeMX.Per RNG internal peripheral - stm32mpu, the RNG1 peripheral should be a single choice assignment. When I click on A7S (OP-TEE), the tool warns me that it cannot be removed from the A7S conte...
Hi,we are generating STM32MP1 Code with CubeMX under Windows and add the needed lib file as references.That creates a link for each library in the CM4/.project file. <link> <name>Drivers/STM32MP1xx_HAL_Driver/stm32mp1xx_hal.c</name> <type>1</...
Hello,with CubeMx 6.9.2 i am generating Code for CubeIDE with the goal to figure out which periphery is assigned to the CA7 or the CM4.With Freemarker it is possible to get information about which IP's are assigned and used but i have no idea how to ...
Select a new prject in CibeMX this case STM32Mp157AAA ) Select PZ1 and PZ2 pin. Configure Pz1 output assign PZ2 for EXT IN and assign to Cortex M4Generate MX output fileIssue 1: No GPIO pin initliaziation code is generated !Load project i n AX6 work...
STM32MP157AAA custom board with DRAM, SD- EMMC, USB and UART , Discrete power( no PMIC) . The board uses discrete oscillators for HSE and RTC, so they are set as Crystal OSC for both in CubeMX USB, UART are correctly configured (same as the default...
I'm trying to use the TIM internal peripheral as an events counter on an STM32MP15. I have the ETR pin connected to a line generating pulses. When I tried to configure the trigger in STM32CubeMX,I was unable to select the ETR trigger when TIM1 was co...
