Using the latest CubeMX 6.9.0 on Ubuntu 23.04 The following has happened quite a few times in the past years , also on previous Linux and CubeMX versions. Now would like to raise this issue as it's becoming very annoying now doing more work in Cu...
I'm trying to use the TIM internal peripheral as an events counter on an STM32MP15. I have the ETR pin connected to a line generating pulses. When I tried to configure the trigger in STM32CubeMX,I was unable to select the ETR trigger when TIM1 was co...
I am trying to configure some HW IP to work with the M4 core of the STM32MP157, I can find only the GPIO already assigned to other IPs ont he development Kit.How to configure GPIO's and configure interrupts related to SPI DMA from the M4 side?Attache...
We are using the STM32MP157AABx device in our project and updating to the v5.0 Ecosystem and STM32CubeMX v6.9.0.When we generate our device tree files, the optee-os device tree tries to include:#include "stm32mp15xxab-pinctrl.dtsi"This file is not fo...
"Does this mean that I can only use the other three options exclude 'free' in either M4 or A7 and cannot switch between them?"
Hi, I have a STM32MP157A-EV1 board. I'm running it in the engineering boot mode and programming the Cortex-M4 directly through the STM32CubeIDE. At the moment, I do not use the Cortex-A7. I would like to enable USART2 and use it through the ST-LI...
Hello, I am trying to manage some interrupts in the M4, specifically the Tamper Interrupt. Using the STM32CubeIDE (CubeMX) I am unable to select the Tamper interrupt that shows in the NVIC peripheral, when I select it, it gets deselected automati...
Hello, I am trying to associate the DMA1 in M4 context with USART2 but whenever I click "add" on the right pane, I see no USART2 on that, on the contrary, I see UART4 it on DMA2 as shown below. If I try to put DMA2 in M4 context, UART4 now appears in...
Hi, We are using Stm32mp157a Processor in Our custom board. We are configuring PA5 as DAC1_OUT2.We want to configure DMA for DAC. But we didnot get an DMA setting tab in DAC configuration in stm32 Cube mx.How do i enable DMA for DAC? You can see in b...
I am having difficulties activating the EXTI interrupt for a pin in the M4 NVIC. What I did: Opened STM32CubeMX,selected the board STM32MP157F-DK2,opted to configure all peripherals in their default stateActivate SPI5 in the M4 domain, incl. DMA do...