I tried to test a UART link on the USART3 port of the STM32MP157C-DK2 board.For that I followed the instructions of the Wiki for the modification of the Linux kernel:I changed the settings in "arch / arm / boot / dts / stm32mp157a-dk1.dts" to put the...
I have a STM32MP157C-DK2 eval kit and am looking into Bluetooth mesh. According to Murata the wireless \ bluetooth module that contains a Cypress part is mesh compliant and the board has v5.50 of BlueZ so theoretically the version of Linux supports i...
I am going to extend some GPIO for 157 for keyboard, I found on EV board is a MCU of STM32L157 to implement, do you have any firmware information about this MCUSource code or I2C protocol, or have other similar chips
Hello.I've created basic image with FlashLayout_sdcard_stm32mp157c-dk2-basic.tsv from stm32mp1-openstlinux-4.19-thud-mp1-19-02-20 downloaded from site. And I can't normally enter to any low power mode: stop - "systemctl suspend" or "echo mem > /sys/...
Hi Folks,I am building openstlinux-weston/st-image-weston image for stm32mp157c-dk2 board using newest Yocto distribution provided by STM. Everything works fine except the output goes always to HDMI (even if no cable attached). I can see bootloader s...
Can anyone point me to an example on how to use bluetooth for this discovery board? Will it be possible to pair to two bluetooth sensors at the same time?
Hi, We have an reference board for STM32MP157A-DK1 and in the board there is no Bluetooth module and Display in built.So is there any possibility to purchase the Bluetooth and Display modules and interface to the existing reference board.RegardsSri...
I'm trying to build an image for the STM32MP157C-DK2 board using the standard unmodified OpenSTLinux yocto build.The build is successful and the image boots fine, but Bluetooth does not work with the basic image (it works with the trusted image).Usin...
Hi, everyone, I use STM32MP157C-DK2 on my macos(Mojave) laptop. I saw other threads the stlink can not install some driver on macos. but I can not see any /dev/tty.* device, Does I missing some config thing?