GNSS positioning

cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

LIV4F firmware update protocol

Hi, We're attempting to update the LIV4F firmware via the UART interface from an embedded device, however, we're unable to replicate the steps documented in UM3009.Our code works up until the the baud rate configuration step in Figure 2, after which ...

kpw by Associate
  • 61 Views
  • 0 replies
  • 1 kudos

Resolved! Teseo-Suite activation

HelloI need to use full featured Teseo-Suite.Sending letters to st-teseo-suite-support@st.com remain unanswered.How could I obtain a full version of Teseo-Suite?Thanks

ASamo.2 by Associate II
  • 140 Views
  • 4 replies
  • 2 kudos

Resolved! X-STM32MP-GNSS2 Antenna

Hi,The BOM and almost all pictures of X-STM32MP-GNSS2 include a Taoglas antenna.Could you verify if an antenna is actually included or not, if I order an X-STM32MP-GNSS2?

rvl by Associate
  • 751 Views
  • 7 replies
  • 13 kudos

STA8090F4GBTR defect analysis requirement!

你好!这种材料(STA8090F4GBTR)在我们项目的生产测试中存在低功耗问题,缺陷率约为0.8%,给我们的生产和维护带来了极大的不便。我们现在需要贵公司的协助来分析芯片体缺陷的原因。谢谢!

hebin987 by Associate
  • 229 Views
  • 2 replies
  • 1 kudos

Teseo Suite activation

Hi, I am trying out EVB-VIC3DA and would like to use Teseo suite with full function. I am sending activation request e-mails to st-teseo-suite-support@st.com using request forms generated from Teseo Suite, but haven't received any response yet. Could...

ryomatsu by Associate
  • 1470 Views
  • 4 replies
  • 1 kudos

Resolved! Teseo-LIV3FL vs. Teseo-LIV3F

Hello!Can you please help with the differences between Teseo-LIV3FL and Teseo-LIV3F modules, does LIV3FL have all the features of LIV3F plus low power, are there any reasons why to prefer LIV3F over LIV3FL nowadays, or it is recommended to always use...

aziubin by Associate II
  • 1161 Views
  • 2 replies
  • 1 kudos

Teseo-LIV4F fix rate slower than it should be

Hello,I am working with a LIV4F, and I am trying to configure the fix rate at 10hz like so:$PSTMSETPAR,1130,0x00,0$PSTMSETPAR,1303,0.1,0$PSTMSAVEPAR$PSTMSRRThe LIV4F responds with:$$PSTMSETPAROK,1130*30$$PSTMSETPAROK,1303*32$$PSTMSAVEPAROK*5CAll appe...

mf-ff99 by Associate II
  • 625 Views
  • 1 replies
  • 0 kudos