Hello!Is external antenna included with X-NUCLEO-GNSS1A1 board (or X-NUCLEO-GNSS2A1) or it should be purchased separately? GNSS expansion board based on Teseo-LIV3F module for STM32 Nucleo Data brief does not mention external antenna, but Getting sta...
Hello,I am working with a LIV4F, and I am trying to configure the fix rate at 10hz like so:$PSTMSETPAR,1130,0x00,0$PSTMSETPAR,1303,0.1,0$PSTMSAVEPAR$PSTMSRRThe LIV4F responds with:$$PSTMSETPAROK,1130*30$$PSTMSETPAROK,1303*32$$PSTMSAVEPAROK*5CAll appe...
I installed the Teseo-VIC3DA Evaluation Kit to my car and drove for about half an hour. The "sr" field of PSTMDR2 showed "system ready". Then I disconnected the antenna to test the DR mode. The accuracy of the DR seemed not good (the error was around...
Hi,I bought a Teseo-VIC3DA Evaluation Kit and when I went through the associated documents, they mentioned the concepts of "Teseo-DRAW and Teseo-DRUM". In my application, we do not have access to the vehicle's wheelticks/direction information so I gu...
I have recently procured a X-NUCLEO-GNSS1A1 on its own. I would simply like to use the LIV3F to test the LNA/SAW filtering along with different antennas as well. I am able to connect the LIV3F to Teseo Suite via FTDI -> UART. I can see all of the sat...
Hello,I am able to receive data normally when connecting USB with Teseo Suite, but when I connect using Terminal software, there is no data output at all. I am sure the baud rate is 460800. Is there a specific command I need to input for it to start ...
Hello community users! There is a question that needs to be asked. Any help would be greatly appreciated! We want to know Can S2_LP UHF module receive the differential correction data generated by our own gnss base station? So we'd like to know the s...
Hi,I am new in TESEO VIC3DA. I have designed a board communication between MCU and TESEO VIC3DA.Does TESEO VIC3DA auto send NMEA sentences to my MCU through uart peripheral ? Thanks
Hi all,I have been doing some experimentation with a LIV4F module and am trying to configure the device for a 5Hz data output rate. I see the device supports up to 10Hz.The commands I have tried via teseo suite are:$PSTMSETPAR,1190,0.2 followed by $P...
Hello I am interested at looking at the Teseoo-LIV3F for a application but I require a very fast TTFF. Having read up on the A-GNSS option will this be available any where or any location in the world as long as the server is accessible ?So no matter...