Hello, We propose using Teseo-LIV3FL to design a new product. This part is selected because it supports Differential GPS (SBAS) and Real-time AGNSS.Please let us know if LIV3FL supports NAVIC (IRNSS). If not, can we upgrade the firmware to support NA...
Hello, I am currently working with the NUCLEO GNSS2A1 extension on the NUCLEO-L010RB demonstration board, and I am trying to retrieve data from the gyroscope and accelerometer. According to the TESEO VIC3DA module documentation, there are two modes...
Hi All, We are planning to use the STA8090FG GPS receiver for a project (https://www.st.com/en/positioning/sta8090fg.html). We are not able to find any reference schematic/design online. Just wondering if there is any example schematic design for thi...
Hi,I have a EVB-LIV4F. I would like to know how to enable RTCM message. I would like to extract the following raw measurements from RTCM:1) the time of the measurement2) satellite pseudoranges measured between the satellite and GNSS receiver3) their ...
Hey!I updated the firmware to the ME version, I am receiving some RTCM messages, but only a limited amount shows up in the message monitoring, also nothing can be decoded. Is there any documentation available on how to configure which RTCM messages s...
Hi,I bought an EVB-LIV4F to evaluate LIV4F and I have sent two emails to st-teseo-suite-support@st.com to request activation code. Unfortunately, I haven't received any response. Is it possible to check whether ST has received my request?Thanks.
HelloI need to use full featured Teseo-Suite.Sending letters to st-teseo-suite-support@st.com remain unanswered.How could I obtain a full version of Teseo-Suite?Thanks
HelloFP-ATR-ASTRA1 - platform STEVAL-ASTRA1B, Teseo-LIV3F GNSS moduleOutdoor GPS not working, Requesting help to fix this. latitude: 0.0, longitude: 0.0, altitude: 100.0 Thank YouSudhir
Hello,I'm using a Teseo III module from Lantronix. When connected up, I can see NMEA sentences over UART, at 9600 baud.I have a few questions. I'm not a GPS expert, and unfortunately, the Teseo III documentation assumes quite a bit of knowledge.Quest...
Hi,I would like to know if EVB-LIV4F has USB linux driver. I would like to connect EVB-LIV4F to a ubuntu computer.Thanks,Koon