About PGump.1

PGump.1 · 2024-04-11

Hi all,I have a simple project using a STM32C011J4. Using STM32CubeIDE V1.15. I compile it for both Debug & Release.I program it via STM32Programmer V2.10.The Debug elf file works okay, however, the Release elf does NOT run…Yes! I have checked that t...

PGump.1 · 2024-03-20

Hi,I'm wondering why Option bytes, OTP, and other such regions of Flash are not part of the STM32CubeIDE tool chain?Kind regardsPedro

PGump.1 · 2024-03-19

Hi all,I'm trying to install STM32CubeProgrammer V2.16 on Linux-Suse-Tumbleweed, but I'm having problems:-I have downloaded and unpacked en.stm32cubeprg-lin-v2-16-0.zip (generic linux).user@localhost:~/STMicroelectronics/STM32Cube/STM32CubeProgrammer...

PGump.1 · 2024-03-19

Hi all,I have a STM32C011 project. I am using a STMF0-Discovery as a ST-Link, as I have done many times before.I have upgraded STM32CubeIDE to V1.15. It is asking me to upgrade the firmware in the ST-Link. Going through the upgrade process, it fails ...

PGump.1 · 2024-02-22

Hi all,The last two times I have exited from STM32CubeIDE it has locked up. Does anyone know how to fix this?My system is Linux, Tumbleweed, Plasma (X11), Cube V14.0.When I Exit, I get the Exit confirmation message box, I select Exit - then the my cp...

PGump.1 · 2024-05-01

I would conditionally agree with @david Littell… If your target MCU and debugger don’t share a come ground, yes, this can be problem. If you have a project where you need this functionality, then use a connector style that connects the GND signals fi...

PGump.1 · 2024-04-30

Hi,I think you misunderstand - it is NOT disconnecting that is the issue. It is connecting, and the power On sequence that is the issue...Kind regardsPedro

PGump.1 · 2024-04-30

Hi,Although Latchup can cause chip-wide damage, the damage is usually limited to the pin(s) affected. Chip-wide damage often comes with over current, over temperature, and sometimes smoke... Most modern silicone fabrication techniques have an inheren...

PGump.1 · 2024-04-30

Hi,Any system where pins are interconnected between parts of that system that are powered separately, need additional design consideration.In your case, a possible scenario could be - Your ST-Link is powered up (via USB), you plug it into your board ...

PGump.1 · 2024-04-29

Hi,Your diagram is not clear here. However, it is most likely that the NRST pin has failed due to Lactchup. This is usually caused by a bias voltage placed on the NRST pin when VCC is transitioning from 0 to 3.3V...I hope this helps...Kind regardsped...

User statistics

User Activity

Release build won't run

Option Bytes, OTP in STM32CubeIDE

Linux install - how to?

STM32CubeIDE V1.15 ST-Link upgrade problem

STM32CubeIDE locks up on exit

Re: STM32F767 NRST held to VSS

Re: STM32F767 NRST held to VSS

Re: STM32F767 NRST held to VSS

Re: STM32F767 NRST held to VSS

Re: STM32F767 NRST held to VSS