STM32CubeProgrammer v2.17.0 release information New features:• Added the support for the STM32MP25xx microprocessors in the STM32MP2 series – Flash memory and OTP programming, SSP support Added the support for devices in the STM32WB0 series: STM32WB0...
Hi,i currently trying to interact via shellscript and stm32cubeprog cli with my stm32mp157 board.I can run and load tfa and than uboot. But when i want to read otp, my operations get stuck.What is the correct call for this?In my Script is use the fol...
I am stuck at step 6 inhttps://wiki.st.com/stm32mpu/wiki/Getting_started/STM32MP1_boards/STM32MP157C-DK2/Develop_on_Arm%C2%AE_Cortex%C2%AE-M4/Modify,_rebuild_and_reload_a_firmwareMPU Serial Console is operational, ethernet RJ45 also, and serial port ...
Hey.. there I hope all are doing well I have just upgraded my Ubuntu desktop version from 18.0 to 20.04Right now, I'm playing with STM32MP1 and that's how to flash the new image i have downloaded the STM32Cube programmer Linux version 2.8.0After succ...
Hi When generating for CubeIDE firmware executes fine in both production and engineering mode. But for IAR/EWARM only engineering mode works. And, yes, I am aware of production mode not supported out of the box. Manual copy to target and start requ...
I'm creating a project using STM32CubeIDE for the STM32MP1. I've followed the steps outlined in AN5630. I notice in the root project, under CA7\DeviceTree, that the directories for kernel, tf-a and u-boot are created. I'm planning on creating either...
- Create the directory for the project (C:\Project)- Create a New STM32 project- Select the processor and package- Setup STM32 project > Enter project name, for location enter project directory, select language and project type STM32Cube- Code Genera...
Hi,We are using stm32mp157a-dk1 target.I have an issue i.e,when i use uboot source code dts file in u boot source code its works fine.when i replace original dts with stm32 cubemx generated dts it didn't works.Can i use cube mx generated dts in plac...
I am trying to Debug m4 in production mode. M4 is not halted.I am getting an error "Failed to insert breakpoint".I can successfully debug in Engineering mode. but, I need to Debug in Production mode.Can you explain how to solve this issue?
I've build all part (linux, tf-a, u-boot) in stm32cubeide, acording to my device tree configured in cube.I would like to ask if there is short way to create sd-card image from cube gui? If not, could any one share way how to do that from build to rea...
Hey , In the OTG block diagram (attached below ) pin PA11 and PA12 can be configured as OTG_FS but using CubeMx we can't set the functionality of these pins.
