Unsufficient disk space on current disk

[alpaltunsoy]

Hello everyone, i am currently working on STM32 NUCLEO-L073RZ Projects with Ardunio Ide. I did not change anything from yesterday only i install mbed studio and after installation i delete. I did not do anything with mbed just installation,  and i took these errors attached with pictures. There are also Fail.txt file in Disk. How can i solve problems. All jumpers are located in correct place.

Sketch uses 8024 bytes (4%) of program storage space. Maximum is 196608 bytes.
Global variables use 868 bytes (4%) of dynamic memory, leaving 19612 bytes for local variables. Maximum is 20480 bytes.
"C:\Users\alpal\AppData\Local\Arduino15\packages\STM32\tools\STM32Tools\1.4.0/tools/win/massStorageCopy.bat" -I "C:\Users\alpal\AppData\Local\Temp\arduino\sketches\03AC7BC7F6E3ABB77F4268DAA235E17A/sketch_may14a.ino.bin" -O "NODE_L073RZ"

Insufficient disk space on current disk.
Insert another disk and type <Return> to continue...

Insufficient disk space on current disk.
Insert another disk and type <Return> to continue... Failed uploading: uploading error: exit status 2

[Tesla DeLorean]

And the SIZE of the .BIN is WHAT?

Can you drag-n-drop it manually?

What version of firmware is on the ST-LINK/V2-1 ? If it is old, perhaps use the update from sTM32 Cube Programmer.

[Andrew Neil]

As you're working with the Arduino IDE, and these messages are coming from the Arduino IDE, you'd be better asking on the Arduino IDE forum:

IDE v1.x: https://forum.arduino.cc/c/using-arduino/ide-1-x/18

IDE v2.x: https://forum.arduino.cc/c/software/ide-2-x/93

[alpaltunsoy]

I added STM32CUBE IDE pictures i am taking another errors as you can see

[Andrew Neil]

Pardon? I don't understand!

You said you were using the Arduino IDE ?

Please clarify!

[Andrew Neil]

---

@alpaltunsoy wrote:

There are also Fail.txt file in Disk.

---

So what does that file tell you?

What "disk" is it on?

[alpaltunsoy]

My STLINK is updated but it does not working

[alpaltunsoy]

[Tesla DeLorean]

I wonder if you've crashed the chip, or stuck it in low power mode

Jumper BT0 and VDD (ie BOOT0=HIGH) so that it boots the system loader rather than user space code.

See if you can connect in STM32 Cube Programmer, and then mass erase part.

[Tesla DeLorean]

It think the screen shot is showing CubeIDE as unable to connect to the target. Failed file probably communicating something similar.

Check also the pair of ST-LINK jumpers on the NUCLEO, that it can connect to the TARGET.

Try the BOOT0=HIGH method I describe in the other post.

Also check current measurement jumper is connected, otherwise the TARGET will not be powered.

Check 3V3 supply at IC