Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
I have 75s battery pack and i want to make short circuit protection circuit and load switch circuit. I facing some problem regarding finding MOSFET at at 288 volt and max 60 AMP continues current. Can any one suggest any MOSFET or digital switch whi...
helloits not that clear what the manual and data sheets say about the "configururable clock otput register.normaly i set port d as output with portd cr1 alsso setthen i set the ccoen bit in the clk_ccor registerthen i write 15 in clk_ccor register...
Hi,I'm using STM8S for UART half duplex communication (single wire). I'm using the standard library to set the UART up in 9600 baud rate, 8 data bit, even parity and 1 stop bit. I recieve data using interrupts. On the third byte, I get a parity error...
There seems to be a bug when activating a Soft Access Point for the B-L475E-IOT01A MB1297D. The problem is either in the Wi-Fi module's firmware or in the es_wifi drivers in STM32Cube_FW_L4_V1.11.0 and STM32CubeExpansion_Cloud_AWS_V1.2.1. The es_wifi...
Hi everyone, I'm designing an application with an STNRGPF02 and would like to generate an appropriate firmware for it.I made the conception using the STNRGPF12 design, since the chips are very similar and the PF02 is not available through eDesignSuit...
Hi,I have just downloaded and am about to install e.st-stm32cubeide_1.0.2_3566_20190716_0927_amd.deb_bundle.sh.zip onto Kubuntu 19.04.As STM32CubeIDE seems to contain STM32CubeMX I was wondering if it was still necessary to install both openjdk 8 and...
Hy,can i change opto CTR and so on?regards Tiziano
I just started to working on STM8L162. I worked on STM32 SO, I searched the tool like STM32cube MX for STM8 and I got it. STM8CubeMX does not support the code generation yet. So , is there any other tool for STM8? From where I can download the driver...
