Atollic TS & CubeMX on Windows 10 - any knowing trouble?
i'm going to update my Win7-Professional to Win10; my question is :there is any knowing trouble to run Atollic TS or CubeMX on Windows 10?
Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
i'm going to update my Win7-Professional to Win10; my question is :there is any knowing trouble to run Atollic TS or CubeMX on Windows 10?
I have a burned SMD Diode and I can see the ST Logo, the code LE and the date Z751 on it. Which part do I need to repair my device? Thank you.
M41ST85WMX6TR contains an embedded 32.768KHz crystal, but it has not any crystal’s information in RTC’s spec or design note, so what's the crystal used in M41ST85WMX6TR? Or what's the embedded crystal's electrical parameter
Hi all,Attached my design with HVLED001 does not work. If i replece HVSU resistor with 1kOhm starts to works and output is ok but IC temperature getting very high quikly abouve 100C degree. IC supply voltage is okey and about 17-18VDC. I can not whe...
Hi,The controller part number mentioned is obsolete now.Controller : STR912FAW47X6We are looking for new microcontroller were we can port the source code into the new one with no/minor changes. The Workbench details are also mentioned.CrossWorks for...
As per M24128 datasheet, to read data from memory i am using random access + sequencial read. But when i tried to read continuously 500 bytes it is hanging some where . so i tried as reading 250 bytes then i have give a small delay then reading next...
using the USBUF01W6 IC for self powered USB device with full speed connectionCan i give 5V DC volt BUS POWER from HOST to it? as it will also be used for pullup on D+ lines
I'm running STM32L072RZ and am running into weirdness with the EEPROM. I'm using the Cube32MX HAL library so I can avoid any potential issues. Below is my routine. Sometimes it runs just fine. Other times, it crashes my debug session and doesn't even...