Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
i have tried different frequencies , modes but no result.
Hi,we are using the ECMF02-2AMX6 in our USB 2.0 lanes. The traces on our board are quite short. However, the measured eye diagram of USB 2.0 was not good. The eye is very close to the limit especially at the rising part. Now I saw that in the datashe...
Dear support,When debugging code in Attolic TRUEStudio I am facing a fantom breakpoint phenomena. Sometimes I see this report from ConsoleTemporary breakpoint 1, main () at ..\src\main.c:71 71 int ret = 0; No breakpoint number 2.It's a sh...
Hello, I tried SD install spc5 studio but it does not start? How can I solve? Thank you
I want decompile STM8S208 code file. File format is .S19. What should be the steps I should follow?
Hi Sir/Mdm,Would like to know is there any solution for OTA (Over-the-Air) upgrade firmware for STM8?Regard'sJason
We’re using STM8S207RBT6C for our current production. Due to the on-going IC shortage matter, we're trying to source a alternatives that can directly working on our existing design without any hardware nor firmware changes. We were able to find s...
I have configured the timer as below is its is correct and also in interrupt handler I am not getting time the values.static void TIM3_Config(void){ /* TIM3 configuration: - TIM3CLK is set to 16 MHz, the TIM2 Prescaler is equal to 16 so the TIM2 co...
Hi,We have a requirement of support for CAN Open and CAN J1939 on STM8AF5288T.We found a website: Simma Software which provides this support but we want to confirm if STM officially supports their CAN Open and CAN J1939 stacks for STM8.Kindly let us ...
