Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
I have a STM8/128-MCKIT motor control starter kit. I am following hardware configuration specifications, but I keep getting the 'Under Voltage' fault. I am using the default BLDC motor and board configuration with an external power supply. Thanks ahe...
Program STFlasher. Connecting K-L-LINE. Press button "Reload monitor". Error:InitMonitor failed.BSL: Fail before sending all the 0x20 first bytes.At the same time, everything is fine on another old computer (Windows 98).Help please!
Hi team,Hope you’re doing well !!please provide MTBF/MTTF data & Thermal Impedance(Junction to Ambient) information for Below MPNs for reliability analysis of our Board.MPN: ECMF02-4CMX8 ECMF04-4HSWM10 STELPD01PUR M41T00SM6...
What would cause an application to crash the debugger and not be able to reset in the debugger, without exiting the debugger? I am just about finished with my application I have been working on for a few months.The processor is a STM32G051K8T and I h...
Hello All,Can you please help in calculating the thermal constant (c= 0.05 /degC) of schottky diode in general? How can i calculate it for any?Was going through one of STM application note on thermal runaway of schottky diode (STPS80L15C). App note :...
Hello, I am working with an SPI M95M02-DR EEPROM in a Cypress PSoC Creator enviroment.The M95M02-DR is running on a 1 Mbps SPI bus.After each buffer write, a delay of 20 ms is used.If 0xFF is written to all bytes of a page or if random values are wri...
Hi every one,I have bought Stm8 Discovery board which has touch button onboard. After that I have download STM Touch Sensing Library, and some arrangements done at ST visual Develop IDE, directly build main c file and have been uploaded by using ST...
I used the ST eDesignSuite to make a o 90V-265V AC power input to +12V with 0.8A and -12V with 0.2A output. So I purchased all the components and soldered the pcb as below,fig1. Soldered PCBCircuit - Schematic which was taken by eDesignSuite as below...
