Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
I am having a communication problem with MAX485 ic. I am trying to change Ic receiving mode to transmit mode by using 'PB4' pin and i am using UART1 , SWIM pin as a Transmitter. in some controllers i am unable control pin in the middle working. I am ...
Whenever I open NFC tuning circuit or any other tool in eDesignSuite and click on anything I get "An error was encountered with the requested page." I have tried multiple browsers and in incognito mode and also on multiple devices including mobile ov...
Hi,Please let me know the FIT value calculated as per IEC 62380 and SN 29500 standard.
To introduce the EEPROM M93C66-WDW6TP I need the following information:Number of soldering cycles Orientation (the position of the component in the tape / tray) Packing dimensions stock(Dimensions of the reel / tray / tube) Packing type(The dimensi...
Hi ST family,I want X-NUCLEO-LPM01A's firmware to auto upgrade. Is there any way to do or we should have to do manually?:grinning_face:
Hi All,I am using stm8s001j3 controller, PA1 and PA3 are using as a UART communication by using Remapping. i am able to send the data but unable to receive data. UART configuration is GPIO_DeInit(GPIOD);GPIO_Init(GPIOD, GPIO_PIN_6, GPIO_MODE_IN_PU_...
Program memory write stopped working for me. I tried with two STM8S005K6 chips. And everything works fine if I use some other STM8 chip. Getting below error when trying using STVP.Error : Programming failedError : Problem while trying to Reset swim a...
