Others: hardware and software
Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Forum Posts
Resolved! STM8L ADC Single conversion not working (Solved)
I can't seem to figure out what I've done wrong. Trying to do a single ADC conversion on the STM8L051F3 using pin PC4 but I'm just getting 0xFFFFD. Here's my ADC related code can anyone spot where I've gone wrong?void ADC_Init() { CLK_PCKENR2 |= ...
Cannot figure out how to set the HMAC on the STSAFE-A110
I am trying to use MAC with my STSAFE-A110, in order to further restrict access.I would have expected a function similar to establishing a public key, i.e. StSafeA_PutPublicKeySlot(...), but I can only find StSafeA_PutAttribute.Are we really supposed...
Resolved! How does eDesignSuite calculate NFC matching components ?
Hello, I have to tune several NFC antennas using a ST25R3911b and I would like to automate calculations of the matching circuit depending on the antenna parameters (Rs,L,Rp,SRF). Using the eDesignSuite is a bit heavy since I have several antennas and...
Power dissipation of SMBJ30A/CA for DC operation below clamping voltage
Hi ST Team, i use the SMBJ30A/CA but how much current will be flow if a DC voltage of 40 volt is applied? It must be larger than IBR = 1 mA given in the datasheet. However, there isn't any info for DC operation if a DC voltage above VBR but below VCL...
Need STSAFE-A100 documentation for driver development.
Hi ,Im working on driver implementation for STSAFE-A100 in rust, i need few documents 1)STSAFE-A100 User manual2)STSAFE-A100 Tool kit3)An STSAFE-A100 CrytoKeys4)TN_STSAFE_CmdIf there is any NDA needed to signed what is the process for it?
M41T62 SQW Status when disabled
What is the logic status (low/high/floating) of SQW pin of M41T62 when SQW is disabled (RS[3:0] = 0) ?
