Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Hello,we bought an STEVAL-IPFC01V1 board as reference design for a new product. Now we would like to tune some parameters in the STNRGPFC01 firmware but the IC seems to have disappeared from eDesignSuite. Even a project created with eDesignStudio som...
Here are the references : M24512-DRDW3TP/K (130nm ?) ; M24C32-WDW6TP (400nm ?) ; M93S66-WMN6TP (150nm ?) ; M95128-DWDW4TP/K (150nm ?) ; M95512-RMN6TP (350nm ?). Where can I get those informations ? Thank you. Sébastien.
Hi I was looking into STHV1600/STHV800 Pulser ICs in 3 level mode. As i have understood, they are primarily used in medical applications where it is desired high voltage, short pulses with high frequency range (in MHz range) with short measurement ra...
Hi, my name is Alejandro,I am working with an EEPROM M24C64-RDW6TP which when removing the power does not start correctly in certain cases.Every 100 or 150 reboots, this failure occurs.I would like to know if you can guide me to solve the problem, si...
We have incorporated the VNQ7003 automotive high side switch in out Control unit and have no success in making it work. We implemented all the design and operation steps described in the datasheet and technical references and still have no response f...
can anyone suggest that which is the best for battery application linear regulator or switching regulator.Regulator specifications should be 1) Input voltage 5V-48V 2) 2A current rating3) Output voltage 5V.3) Ultra low Quscient current.please suggest...
I use eDesignSuite to simulate LED5000. In my application I want to use the same circuit for a variety of loads (different LEDs, different current setpoints). From individual simulations I found a set of compromise component values, e.g. 6.8uH for th...
Hi Sir/mdm,I'm now working on the bluetooth section's code and require some technical support.End goal is to get the BLE scanner working via GAP_OBSERVER_ROLE to extract BLE advertising(filter by company identifier and major/minor)Here is the issue a...
Hi there, I am new to the embedded system and now am using M24M01. When I am trying page write with I2C protocol on the EEPROM, I found a weird problem with my oscilloscope. I sent out the command, the waveform is like fig.1, it forms of slave addres...