Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Hello,When I connect USB-C source power to our device, PD sniffer shows Source:DFP sends DR_Swap message to our device, which has a STUSB4500 PD controller. However, our device(Sink:UDP) always sends Reject command. My questions are:Does STUSB4500 su...
Discontinued Products are MAT 90?
Configuration settings are changed via AT commands. By command “at + s.wcfg�? they should be saved to flash. The answer - “AT-S.OK�?. But the next time you turn it on, the factory settings are set. What needs to be done to save custom configuration s...
We are corrently using E-L9823013TR driver Looking for alternate for the same. Kindly suggest us if you have alternates.
Data Sheet of IC ATIC39-B4 A2C08350
We are getting massive ammounts of emissions from the D0 SDIO pin with 120mhz and resonant freqs. The pins for SDIO have been set to AF but nothing else has been setup register wise yet, the circuit was taken from the appnotes with the 3v3 pullups on...