ST10 Flasher interface & Connection.
Posted on August 21, 2009 at 15:11ST10 Flasher interface & Connection. #st10-dump
Posted on August 21, 2009 at 15:11ST10 Flasher interface & Connection. #st10-dump
Posted on July 02, 2010 at 12:30hi, where do I configure the external clock on version 3?Best regards,Rui Serra
Posted on June 30, 2010 at 16:34Hi! I am struggling to make the USB examples (um0290.zip) work on my MB393B (board v2.04, STR710FZ2). I have red something on this forum that some batch of theses board had issues about a resistor on the USB bus, but ...
Posted on June 26, 2010 at 19:50Problem changing banks, again
Posted on June 09, 2010 at 06:41hi~ all I have developed USB firmware. It send audio stream from imbedded board to PC. But I need PC to send some short packet to imbedded board. I want USB device operate as HID and audio(isochronous IN) at the same ...
Posted on June 15, 2010 at 11:27Dear forum members, I need to implement on a st7 mcu a simple and very slow half duplex rs232 like protocol(software emulated).I have only the following resources available: 1 16bit timer. 1 output pin for the tx (a g...
Posted on June 09, 2010 at 03:59Hi all, I am debugging a device which connects to PC through USB cable. On PC side, this USB device has been enumerated as a serial port. It works now, I can see the new COM4 has appeared. The problem is through the ...
Posted on June 14, 2010 at 15:01The ICC Protocol Reference Manual Appendix 1 is an ICC Monitor that I would like to use in a programmer I am writing for the ST72F324. It appears that the icc_drv.asm file is using the upper 252 bytes of the reserved ...
Posted on June 08, 2010 at 08:37Porting Bootloader from STR7 to STR9
Posted on March 04, 2010 at 09:43hi, everyone I want to initialize bss space with ST72324, STVD v4.1.1 and cosmic have only startup file crtsi.s with automatic data initialisation in zero page only, where can i download it? thanks