About AlexCloned

AlexCloned · 2023-09-30

I am renewing this conversation because I had added this concern to a conversation with the same subject that was marked as solved. Originally posted by @MBela.3 .I have not received a response. However, it is very important to me not only for my app...

AlexCloned · 2023-06-06

I see that the VL53L5CX sensor has two voltage supply alternatives, both for the digital part (IOVDD) and the analog part (AVDD). I am also observing that starting from version 1.3.3 of the ULD driver, we have a function called vl53l5cx_disable_in...

AlexCloned · 2022-04-26

I am using STM32CubeIDE V 1.9.0, with an Nucleo board with STM32F401, and STLink integrated. Debugger just stopped working. I have spent hours trying to change debugging configurations, upgrading STLink firmware, but nothing. When I press Debug I see...

AlexCloned · 2022-04-01

When filling the struct in my apptypedef struct { uint32_t RangingProfile; uint32_t TimingBudget; /*!< Expressed in milliseconds */ uint32_t Frequency; /*!< Expressed in Hz */ uint32_t EnableAmbient; /*!< En...

AlexCloned · 2021-12-20

After been testing VL53L3CX in my own board based in a STM32F407 micro, I want to test VL53L1CB now. But I am not wiring (satellite board) to a Nucleo board. I have connected it to my own board and trying to reformulate the project with STM32CubeMX. ...

AlexCloned · 2024-08-23

Doug, I know your work is ongoing and it may be tedious to report every detail in this forum. Just one detail that hasn't been mentioned: consider the possibility that your sensor might momentarily lose track of the distance to the target—the plastic...

AlexCloned · 2023-11-17

Hello @MasterNi . We are sharing similar problem. I have the feeling that with a comprehensive explanation of these codes, particularly those that are not self-explanatory, we could make some better sense of a significant amount of data. In a conti...

AlexCloned · 2023-11-09

Assuming that if you're using the Satel-Vl53l8 development board, you shouldn't have PCB layout errors, as it's already proven by your successful initialization. This leads us to believe that the read data does not match the expected quantity or ther...

AlexCloned · 2023-11-09

We must clarify that what matters is that normally the target is more than ten times the distance presented by the chip between the optics of the emitter (VCSEL) and that of the receiver (SPAD). Let's say if this distance is 3 mm, then the cones ov...

AlexCloned · 2023-11-03

Yes, it is possible to detect glass if you position the TOF sensor in front of the glass so that the laser hits at angles close to 90 degrees. Since glass is not 100% transparent at 940 nm, you can expect to receive photons back on the sensor, reflec...

User statistics

User Activity

VL53L5CX: Info about target status [renewed]

VL53L5CX ULD and device power consumption

STM32CubeIDE debugger not working

VL53L5CX ULD. Is Timing Budget equal to Integration time for Autonomous ranging mode?

What is the STM32CubeMX extension for ToF sensor VL53L1CB, with bare driver support?

Re: Use of VL53L1X

Re: VL53L5CX status Mean

Re: Unable to start ranging on the vl53l8cx

Re: System Field of View (Measurement Area) of VL53L4CD and Similar ToF Sensors

Re: VL53L7CX - Can it detect glass walls?