I bought a STEVAL-55G0MBI1, which is the VD55G0 S-Board eval kit.
Trying to output the image to my PC, nothing is coming out.
What could be the issue with my setup?
Guide to view histogram data on the VL53L7CH and VL53L8CH
We often receive questions on the ST Community regarding the histogram data on these products. The following article is written to assist you in viewing histogram data on your VL53L7CH and V...
Hello,
Can you let us now which version of the X-CUBE-TOF1 you are using ?
Did you have a look to example codes delivered within the X-CUBE-TOF1 to know how to allocate pins ?
Hello
The accuracy of the VL53L4CD can be found in the table 17 of the datasheet. Unfortunately, the VL53L4CD accuracy is at least +/-6mm with a timing budget of 33ms on a 17% white target. With ToF it is today difficult to get an accuracy lower than...
Hello,We are not sharing a release note for each and every file so you won't be able to find such a document in the package.There is a releaseNote associated to the X-Cube-TOF1.
Hello
The svn repo mentionned above is an internal release and should not appear in there. We will clean it.
Regarding git, the linux driver is not yet available under any GitHub. Sorry for that.
Regards
Anne
Hello,
ST is delivering a package (HW + SW) for each product. Performances of a product are linked to this package. You can give a try and can range with a different SW package but performances won't be guaranteed.
