About Zied b.

Zied b. · 2023-10-17

The documentation of the Board descriptions format is now available on Motor Control Boards Description Wiki page, this documentation is compatible with MCSDK versions from 6.1.2. Board Descriptions are used by the ST motor-control workbench to enabl...

Zied b. · 2023-10-02

Dear MCSDK users, MCSDK version 6.2 is now available: Download It here.Here are the main changes for this version:Hardware Compatibility : C0 Support for FOC 3-Shunt and 6 stepsH5 Support for FOC 3-Shunt and 1-ShuntAdd support of All MCUs part number...

Zied b. · 2023-08-29

In order to have a quick response to your forum posts, the best way to ask the question is:- Give the version of the MCSDK used. - Say if the problem concerns a tool (MC Workbench, Motor Pilot, Motor Profiler, etc...) - Provide picture of tools inter...

Zied b. · 2023-08-29

Motor Control Wiki: STM32 Motor Control Knowledge Database - stm32mcuMC Frequently asked questions (FAQ):Frequently asked questions (FAQ) - stm32mcu The documentation of the Board descriptions format is now available on the Motor Control Wiki: Wi...

Zied b. · 2023-11-08

Hi @Nyam ,it is supposed to work in a lower range and therefore 24-48 should work but it will not work optimally because it was designed to be between 125-400V.Regards

Zied b. · 2023-11-06

Hello @TomChu ,to be compatible with the profiler, the board must be 3Shunt and have an FPU. This board does not do 3Shunt and its MCU (STM32F0) does not have an FPU.Regards

Zied b. · 2023-11-06

Hi @APerr.3 We will gradually add the Resistor Offset necessary to the Boards we support. For the EVALSTDRIVE101 board, I found a Resistor offset of 0.015, you can add "resistorOffset": 0.015, to the Board's .JSON file , Then start your profiling, ...

Zied b. · 2023-10-26

Hi @Jedijump ,This is very good news, what you did is correct. MCSDK 6.2.1 will correct this bug. In the meantime you can use this patch.You can also replace the FTL files, this will save you from copying and pasting the .c and .h each time, you must...

Zied b. · 2023-10-25

Hi @Jedijump ,After analyzing your problem, we found a bug which means that the Hall Profiling part does not work with Boards other than G4. While waiting for the next Release which will provide a Fix to this problem, here is the new Lib that you mus...

User statistics

User Activity

Board Manager documentation is out !

MCSDK 6.2.0 is out!

How to write a Motor control post to get a response quickly

MCSDK documentation and your feedback

Re: New User Looking to Configure STEVAL-IPM30B with ST32

Re: Firmware error detected by Profiler n ST Motor Pilot V1.2.4

Re: Motor profiler MCSDK 6.2.0

Re: How to generate profiler firmware for 6.2

Re: How to generate profiler firmware for 6.2