STM32CubeProgrammer 2.8.0 Automatic mode is not working
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-09-28 08:43 PM
Using ST-link V3.
MCU: STM32L031
First programming was ok. After disconnecting and reconnect with second device, nothing happen.
Using same set of hardware, but changed software to ST-LINK Utility.
Result: ok. Automatically programmed the second device.
Labels:
- Labels:
-
STM32CubeProgrammer
-
STM32L0 Series
11 REPLIES 11
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2023-08-11 09:45 AM
Bump. Would also like help with Automatic mode. First device works, disconnect is detected, but second device does nothing.
STM32CubeProg V2.9.0
STLINK V2J40M27
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2023-08-11 03:16 PM
And why haven't you tested the latest versions first?

- « Previous
-
- 1
- 2
- Next »