1.13.2 problem with List Pinout Compatible MCUs

[padawan]

Hi,

if i select in MX "List Pinout Compatible MCUs"

i get this:

Sometimes STM32CubeIDE closes without warning.

i reintalled the ide, i delete the workspace, i restart the pc, nothing helps! i change in the properties from external bowser (chrome) to internal, nothing.

Any suggestions?

Padawan

[STTwo-32]

Hello @padawan 

I've tested personally for a few times, and nothing happened.

Can you test this behavior with another PC?

Best Regards.

STTwo-32

[padawan]

If i do the same in 1.12.1 i get  this

And this seems ok.

So i think it is one more issue in 1.13.2 :(

Padawan

[STTwo-32]

I don't think so. Doing this operation with the version 1.13.2 I got this:

Can you check your internal parameters? 

Best regards.

STTwo-32

[padawan]

Hm, can you specify which parameters I need to check?

I can't find anything like the "do not deface screen"-parameter, that i

can check..

Padawan

[Bob S · Accepted solution]

Try running CubeMX outside of the IDE.  You will have to install the stand-alone CubeMX it if you haven't already done so.

Personally, I never use the "run CubeMX inside CubeIDE" feature.  It just doesn't provide any benefit.  I generally leave CubeMX running, then open whichever project I need, make changes, same/generate then close the project (and leave CubeMX open).  Then switch to the IDE and re-compile, etc.  Much quicker and easier.

[padawan]

Thanks Bob for the hint

with Cube Mx standalone 6.8.1 it is ok.

with Cube MX standalone 6.10 it is ok,

with the version 6.9.2 integrated in the STM IDE v 1.13.2 -> d'oh

edit:

with the brand new 1.14.0 it is ok (MX 6.10)

padawan