We are pleased to announce that the release 6.14.0 of STM32CubeMX is available. What is new in 6.14.0: Added the support for the STM32WBA6xxx microcontrollers and:Added the support for USBX multi-instanceAdded the support for the memory management to...
We are pleased to announce that the release 1.18.0 of STM32CubeIDE is available. What is new in 1.18.0: Microcontrollers, microprocessors, and board lists aligned with STM32CubeMX 6.14.0: Added the support for STM32WBA6xxx microcontrollers in the STM...
We are pleased to announce that STM32CubeProgrammer 2.19 is available What is new in 2.19: Support for the STM32WBA6xxx microcontrollers: Internal memory programmingOption byte/OTP programmingRDP regression with passwordSFI support Support for MCE N...
Hi,Using own custom board based on stm32mp151I'm using STM32CubeProgrammer to program to nand, but I'm getting errorError: ssbl1 (0x6): Bad size for partition 2 (ssbl1) at 0x200000 = 0xfe00000 <> 0x200000 expected my .tsv file is#Opt Id Name Type IP ...
Hello,with CubeMx 6.9.2 i am generating Code for CubeIDE with the goal to figure out which periphery is assigned to the CA7 or the CM4.With Freemarker it is possible to get information about which IP's are assigned and used but i have no idea how to ...
Is there any documentation or guidance on how to configure Yocto to deploy a custom u-boot image? I've been following https://wiki.st.com/stm32mpu/wiki/How_to_configure_U-Boot_for_your_board and https://wiki.stmicroelectronics.cn/stm32mpu/wiki/STM32M...
I debug a simple project STM32MP15 M4 GPIO-EXTI-CM4, using engineering mode. It worked couple days ago. Today when I tried again, I got the error below and it doesn't make sense.
Hi@Olivier GALLIENI have followed the steps in https://wiki.st.com/stm32mpu/wiki/How_to_create_your_own_machine#Generate_device_tree to generate a image for my specific machines dts. But when building the image the error below is generated. I have do...
I’m new for STM products. After some google, I found mp157d-dk1, I want use it to study Linux kernel. Does the onboard STLink support Linux kernel code debug? Like set breakpoints/single step/observe variables values?Another question, is this boards ...
Hello everyone,I've a question. I want to use a Cortex-A7 on STM32MP13x or STM32MP15x for my project and I would like to parallelize my application. Can I use OpenMP on STM32CubeIDE? Is there a difference if I use OpenSTLinux?
CubeIDE coding section part freezes in my second monitor even though I can restart the program from the file top down menu but it's quite annoying. Is there anyone experienced the same issue ? What would your suggestion be to overcome it ?Distro: Ubu...
I'm using STM32CubeProgrammer to flash my custom target using an STM32MP153AAA MPU. I have onboard a 4GB eMMC memory. During the programming process through DFU all seems good and finishes at 100% but then sits for a bit and I get errors. Seemingly T...
We are trying to achieve the same kind of variable watching Keil has but with the STM32CubeIDE. The variables do not appear in the Variables tab under the Debug view so we added dummy variables to the expression tab. The initial value of the variable...
