We are pleased to announce that the release 6.14.0 of STM32CubeMX is available. What is new in 6.14.0: Added the support for the STM32WBA6xxx microcontrollers and:Added the support for USBX multi-instanceAdded the support for the memory management to...
We are pleased to announce that the release 1.18.0 of STM32CubeIDE is available. What is new in 1.18.0: Microcontrollers, microprocessors, and board lists aligned with STM32CubeMX 6.14.0: Added the support for STM32WBA6xxx microcontrollers in the STM...
We are pleased to announce that STM32CubeProgrammer 2.19 is available What is new in 2.19: Support for the STM32WBA6xxx microcontrollers: Internal memory programmingOption byte/OTP programmingRDP regression with passwordSFI support Support for MCE N...
Hello, I currently working with a STM32MP157D-DK1 Development Board. I populated the board with a prebuild openstlinux 6.1 build. A SSH connection via console is successful.To get the M4 microcontroller running I was able to build a .elf file from th...
The TF-A Makefile.sdk creates a small metadata.bin file for each type of boot (USB, SD-cARD, EMMC)1/ How to generates this outside of Makefile.sdk ? I use this, but is only generates one file and there seems no parameter for the type of the boot dev...
Select a new prject in CibeMX this case STM32Mp157AAA ) Select PZ1 and PZ2 pin. Configure Pz1 output assign PZ2 for EXT IN and assign to Cortex M4Generate MX output fileIssue 1: No GPIO pin initliaziation code is generated !Load project i n AX6 work...
Today got an update message in SW4 Eclipse to update Did that. Now when trying to start "Debug" on an STM32MP1 board Exclipse just exits. The error is as follows. Debug files atttched.Getting frustrated with the AC6/STM32MP1/Eclipse solution as a ...
The Device Tree configuration link . https://wiki.st.com/stm32mpu/wiki/STM32_MPU_device_tree does not include scmi.dstiAfter a rough time lot to wade through trial an errors, we were able to reduce the SCMI errors. First we added #include "stm32mp15-...
For a custom board configured in CubeMX usingSTM32MP157AAA3 , UART4, 512MB DDR3L, (4Gx16) external crystal (HSE, LSE), and discrete power regulator, no PMIC, device trees were generated with CubeMXwhen compiling optree errors and warnings occur.[...
After compiling TF-A, uboot and optee, the flashing of the first mage xxx-usb.stm2 using the CLI tool ends with a wait for completion of the download this fails. The UART report a panic. Any idea how to look further. is this a problems with TF-A devi...
For the MP15 the workshop informs to include, for TF-A vdd_sd for sdmmc1 in the USER section of sdmmc1.. This particular board uses discrete legacy regulator power. when commenting these the lines, the build goes trough. Could this causes issues ? ...
$ make stm32mp15_trusted_defconfig$ make menuconfig# disable PMIC power and enable legacy power in device drivers => power$ savemake DEVICETREE=stm32mp157a-board-mx cleanmake DEVICETREE=stm32mp157a-board-mx allWhy the code needs pmic when pmic is dis...
Example for optee:make -f $PWD/../Makefile.sdk all DEVICETREE=stm32mp157a-board-mxAn error occurs but it stlll generates message with outpfolder and a message that the output files was completed.This happens when the device tree is not found it with...