Hi everyone,
I purchased several boards from Olimex (STM32-E407, STM32-P405, STM32-P407) and I am using the ST toolchain (STM32CubeMX, STM32CubeIDE, ST-LINK/V2, STM32 ST-LINK Utility). The purpose is just to blink a LED.
For the boards STM32-E407 and STM32-P405, I could successfully connect to the boards, build and debug.
For the board STM32-P407, no luck. I can not connect to the target. I tried also STM32CubeProgrammer, but same result.
I have attached the log files generate by the debugger @ STM32CubeIDE.
Not sure what is going on.
Thanks a lot for your time
