Nucleo User Manuals don't show the VCP UART connection
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-02-28 2:51 AM - edited ‎2024-02-28 3:03 AM
eg, UM2179 STM32 Nucleo-144 boards (MB1312):
Related:
- Labels:
-
Documentation
-
ST boards
-
ST-Link
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-02-28 2:56 AM
Also UM1724 for the Nucleo-64s:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-02-28 2:59 AM
UM1956 (Nucleo-32) just doesn't label the connection at all:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-02-28 3:01 AM
But UM1974 for Nucleo-144 boards (MB1137) does show it!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-02-28 3:02 AM
An internal Ticket 174798 has been raised to fix the issue.
Thank you @Andrew Neil for raising this.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-02-28 3:29 AM
Reported also for UM1956 and UM1724
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-02-28 3:44 AM
Probably also worth a general check on Discovery and other boards ...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-09-18 5:59 AM
@mÆŽALLEm wrote:An internal Ticket 174798 has been raised to fix the issue.
Thank you @Andrew Neil for raising this.
@mÆŽALLEm Any update on this?
The manuals have not been corrected yet, and this continues to cause confusion:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-09-18 6:33 AM
Unfortunately not yet and I don't have a visibility on this fix.
The only info is just this will be applied to the new Boards' UMs. For the old ones I cannot confirm.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-11-12 3:36 AM
